Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Get your free estimateGarage Door Company in Venice, CA
Garage door installation in Venice means working with 1910s and 1920s bungalows, beach cottages, and rear-alley garages that were never built for a modern door. Most jobs off Rose, Electric, and the side blocks of Abbot Kinney are tight-back-in, low-clearance retrofits, not clean new-construction installs. The salt off Santa Monica Bay also eats bare steel faster here than inland. Wright Garage Door Repair has served Venice since 2017, and we stock the parts and knowledge to handle both the door and the opener in one visit. Call (855) 362-1465 for a free estimate.
Why Venice Homes Are Different
Venice’s garage-door challenge starts with the alley. The historic bungalows and courts west of Lincoln face their garages onto narrow, shared rear alleys, not street frontage. That means a technician is often backing a truck into a 10-foot-wide lane, carrying panels around a trash enclosure, and working inside a garage that was sized for a Model A. The openings are undersized, the headers sag after a century, and the spring systems were rarely sized for a modern insulated steel door.
Then there’s the marine layer. Venice sits under morning fog most of the year, and the onshore air carries salt from Santa Monica Bay. Bare-steel doors, torsion springs, hinges, and rollers here pit and rust noticeably faster than they do in Culver City or Ladera Heights. Wooden alley doors swell at the bottom rails and rot where they meet the slab. A door that would last 15 years inland often needs hardware replacement at the 8-year mark in Venice. Every job we quote accounts for that.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Our Main Venice Services
Most Venice homeowners call us for one of two things: a door that won’t open or an opener that won’t respond. Both have their own dedicated pages, and both are covered by the same team.
Garage Door Repair in Venice
Broken torsion springs are the most common repair call we get in Venice, followed by rusted rollers and cables that have snapped inside the tracks. The salt air accelerates all three. On alley-facing garages, we also see a lot of track damage from cars that have to back in at an angle. Whatever the cause, we arrive with parts for Chamberlain, Genie, and Clopay systems on the truck, and we quote the full price before any work starts. Full details are on the Garage Door Repair in Venice page.
Garage Door Opener Repair in Venice
Openers fail differently in Venice than the doors themselves. The damp air corrodes circuit boards, and the tight ceiling clearances in old alley garages stress the trolley and belt. We repair drive systems on LiftMaster, Chamberlain, and Genie units, and when a motor is beyond saving, we replace it. The full scope of that work, including prices, is on the Garage Door Opener Repair in Venice page.
Garage Door Installation in Venice
Installing a new garage door in Venice rarely means ordering a standard 16-by-7 and bolting it in. The century-old detached garages off the alleys were built for cars that no longer exist, and many have been carved up for surfboards, bikes, or ADU conversions since. We measure every opening, check the header, and spec low-headroom track or custom panel sizing when the ceiling won’t clear a standard radius. That’s the work we do under Garage Door Installation, and it’s the only way a door lasts here.
Garage Door Replacement
Signs you need it
The bottom panel is rusted through at the rails, the door binds every few cycles, or the panel skins have separated from their frames, which we see constantly on beach-adjacent alleys.
What it costs in Venice
A full replacement in Venice runs $700 – $2200 depending on panel count, window cutouts, and whether we’re reusing the existing tracks or replacing them too.
How we do it
We measure the opening, check the header and jambs, remove the old panels and hardware, install the new sections with fresh rollers and hinges, then balance the springs to the new door weight.
Garage Door Installation Service
Signs you need it
The opening is a non-standard size from a 1920s build, or the ceiling is too low for a standard 12-inch radius track and the door catches on the opener rail.
What it costs in Venice
Expect $700 – $2200 for a full installation, with low-headroom or custom track work adding to that figure.
How we do it
We spec the right door and track configuration for the opening, reinforce the header if it’s sagging, set the panels, install the springs and cables, and test the full cycle under load.
Commercial Garage Door Installation
Signs you need it
Small commercial spaces on Abbot Kinney and Lincoln with roll-up doors that have rusted panels or broken spring shafts need replacement before the door drops mid-cycle.
What it costs in Venice
Commercial roll-up and sectional installs typically run $700 – $2200 for the door itself, and the total depends on the opening height and whether a new operator is needed.
How we do it
We measure the commercial opening, check the structural supports, install the new door with heavy-duty hardware, and set the spring tension for the heavier panel weight.
Garage Door Installation Contractors
Signs you need it
The opening is framed with old dimensional lumber that’s rotted at the base or the header has dropped, making a direct panel swap unsafe.
What it costs in Venice
Full contractor-installed jobs with reframing work run $700 – $2200 for the door, with carpentry scope priced separately after we see the framing.
How we do it
We assess the framing, coordinate the reframe if needed, then install the door system as one complete unit so the panels, tracks, and springs work as a matched set.
Garage Door Seal Installation
Signs you need it
Morning fog leaves a damp line across the slab inside the garage, or daylight is visible under the closed door where the bottom seal has rotted away.
What it costs in Venice
Bottom seal replacement is part of the $250 – $500 panel and weatherseal work we do, and it’s usually done the same day we inspect the door.
How we do it
We pull the old extruded seal off the bottom retainer, clean the channel, slide in a new marine-grade bulb seal, and check that it compresses evenly across the full width.
What Garage Door Installation Costs in Venice
| Item | Typical range in Venice |
|---|---|
| New door installation | $700 – $2200 |
| Panel replacement | $250 – $500 |
| Track realignment | $120 – $240 |
Can you install a low-headroom door in an old Venice alley garage?
Yes. We install low-headroom track systems in the 1910s and 1920s garages west of Lincoln all the time. We measure the ceiling clearance, spec the correct track radius, and build the section count to match.
How long does a new garage door installation take in Venice?
Most standard replacements finish in a single arrival window, usually four to six hours with the old door removed. Custom low-headroom or reframe jobs take longer. We confirm the time before starting so you know exactly what the day looks like.
Brands We Service in Venice
We work on Chamberlain and Genie openers, plus Clopay and Amarr doors, and we carry common replacement parts for each on the truck. That means a Venice alley call doesn’t turn into a two-trip job because we had to order a board or a spring. See our brands for the full list.
See the difference
Before
After
Before
After
Before
AfterPricing for Garage Door Company in Venice, CA
| Service | Typical range in Venice |
|---|---|
| Spring repair | $180 – $340 |
| Cable repair | $130 – $250 |
| Opener repair | $120 – $320 |
| Opener installation | $250 – $550 |
| Panel replacement | $250 – $500 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
| New door installation | $700 – $2200 |
| Garage door repair | $150 – $600 |
What pushes a Venice job toward the top of these ranges is usually rust. Seized hardware takes more time to remove, and panels that have been in salt air for a decade often need replacement instead of patching. You’ll know the full price before we start, and it won’t change after you approve it.
Neighborhoods We Serve in Venice
We cover all of Venice, from the beach blocks to the inland side of Lincoln, including the alley-heavy walk streets and the converted bungalow streets.
- Venice Beach
- Venice Canals
- West of Lincoln
- Abbot Kinney district
- Oakwood
In most Venice neighborhoods we can have a technician out the same day for a repair, and we schedule installation measures within a few working days.
Service Area – Cities Near Venice
Beyond Venice, our trucks cover the neighboring beach and westside cities. That includes Santa Monica, CA to the north, Culver City, CA to the east, and the smaller adjacent communities of Ladera Heights, CA and Century City, CA for homeowners who live just outside the Venice ZIP codes.
Serving Venice, CA - Our Local Coverage Area
We serve Venice and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs About Garage Door Company in Venice
For most repairs in the 90291 and 90294 ZIP codes we can arrive the same day, often within a few hours. Installation measures are scheduled within two or three working days. Call early for repair slots because they fill fastest.
Most direct door replacements on the same opening do not require a city permit. If your alley garage needs a header reframe or the opening is being enlarged, that’s structural work and may need one. We’ll tell you during the measure.
Yes, those are most of our Venice installs. We custom-measure each opening and spec low-headroom track, shorter sections, or narrower doors to fit the original framing without weakening it.
What happens when you call
- 1A real person answersNo phone trees. Talk to a local garage door pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3A background-checked tech heads outLicensed & insured, typically the same day.
- 4You approve before work beginsNothing starts until you say go.
What Venice Customers Say
"Track was bent and two of the rollers were shot. He straightened what he could, swapped the rollers for nylon ones, lubricated everything, and had it done in about an hour."
- Javier Morales"Door installed in about four hours, old one hauled away, and he stayed to program both cars and the wall panel before he left."
- Justin Tran"Logic board on a 15 year old opener. He was upfront that a new opener would cost less than the board plus labor, and he wasn't wrong. No pressure either way."
- Nicole Bennett